Skip to main content

How to uninstall my Check'In?

  • Updated

Uninstalling the Check'In

Via the Check'In App

Open your application, then tap on the profile of the Check'In you want to uninstall. Go to the "Settings" tab, then "Advanced information", located at the bottom of the page. Tap "Uninstall Check'In".

Via the Check'In Pro App

Open your application, then tap on the profile of the Check'In you want to uninstall. Go to the "Uninstall Check'In" section. Follow the steps provided, then tap "Uninstall Check'In".

Via the Dashboard

Go to the Dashboard. Find your Check'In in your organization or enter its IMEI (serial number) in the search bar. Once on the sensor's page, click on the "Settings" tab, then again on "Settings". Scroll down to the bottom of the page until you find the "Danger zone". Click on the "Remove device" button.

 

Check'In Reset

Press the button on the right side of the Check'In for about 9 seconds. Release it once the LED lights up red. You will hear a beep, indicating that your sensor has been reset. 

💡 If you didn't hear a beep, repeat the process!
💡 Wait for the LED to stop blinking red before proceeding to the next steps. Otherwise, the Check'In reset will not have worked, and you will need to restart the procedure.

 

Storing the Check'In

Step 1: Remove the Check'In from its mount

To do this, remove the SafeStick located in the middle slot of the sensor (you can use the tip of a paperclip or pen). Then place it in the slot at the top of the Check'In. Slide the Check'In upwards to detach it from its mount.

Step 2: Remove the Check'In batteries

💡 Wait until the LED no longer flashes red and you have heard the beep. If you remove the batteries before, the Check'In reset will not work and you will have to start over.

Step 3: Detach the Check'In mount

To detach the Check'In mount from the opening, simply pull it off. If you are concerned about damaging the mount, use solvent or a heat source to more easily detach the adhesive strips.

 

Check'In Reinstallation

Your Check'In can now be installed in a new location! 🎉

You can find the sensor installation process in the following two articles: 

Related articles