Once the hub is installed, it should be linked to the Check'In(s) of your choice.
❗Before following the steps below, make sure your Check'In has been previously installed.
1 Go to the profile of the Check'In of your choice. Tap "Diagnosis", then "Change network".
2 Tap "Thread network". The app will search for the hubs you have installed. Select the hub you want to link to your Check'In. If your chosen hub does not appear, tap "Try again".
3 Remove the batteries from your Check'In so that it can pair with the hub.
4 Insert the batteries into the Check'In, then press the button on the device for 4 seconds until the LED flashes blue. Follow the remaining instructions, then tap "Continue". Check that the LED is still flashing blue, then tap "LED flashes". The Check'In will connect to the Thread network.
Once these steps are completed, your Check'In is operational! 🎉