If you are unable to complete the installation of your Check'In Infra 2 Plus, here are the steps to follow:
1 Check that you have inserted the batteries correctly into your Check'In Infra 2 Plus case (observing the + and - polarities) and that they are sufficiently charged.
💡 Also, make sure that you inserted the batteries at the right time, that is, when the application asks you to do so. If you insert them too early or too late, the installation of the Check'In Infra 2 Plus will not be successful.
2 Check that the ribbon of the Check'In Infra 2 Plus is not detached and is properly secured. If it is not, reinsert it into the connector.
3 During the first connection of your Check'In Infra 2 Plus, if the LED blinks slowly in white, it means your device is searching for a network. Please wait until the Check'In Infra 2 Plus finds one.
💡 The connection can take up to 10 minutes. During this time, do not cancel the installation!
4 If the LED of the Check'In Infra 2 Plus does not blink or stops blinking in white, reset the Check'In Infra 2 Plus. To do this, press the button on the right side of the case for 9 seconds, then release it once the LED blinks red. Wait for the LED to stop blinking red before resuming the installation.
5 If you still cannot install your Check'In Infra 2 Plus, cancel the installation and restart it.
6 If the situation persists, cancel the installation, then reset the Check'In Infra 2 Plus by pressing the button on the right side of the case for 9 seconds. Release the button once the LED blinks red. Once the LED stops blinking red, remove the batteries from the case, and then start the installation of the Check'In Infra 2 Plus again.